Coolant leak fix cost11/18/2023 ![]() However after coolant loss, any subsequent overheating may cause the head to warp. In this case there usually isn't any initial gas leakage. ![]() This abraids the silicone sealant in the gasket around the water jacket faces. It's compounded by the fact that Rover located the head on the block using plastic dowels - but that's another story!). This is where the head moves laterally slightly when under heavy load. In this case it's sometimes caused by thermal shock (thermostat suddenly releasing cold radiator water into a hot engine), but more usually by "head shuffle". Perhaps the most common car to suffer almost 100% CHG failure at some point in their lifespan, are the wet-liner Rover K series engines. Sometimes coolant loss via CHG failure isn't down to a warped head. The technology has moved on a long way since then but the damage caused by neglect is never-changing. In the old days (they don't make 'em like they used to, blah, blah, blah.) I saw this happen commonly on Hilman Imps (CHG failure was an Achille's heel with these) where the whole engine was sometime scrap due to hot gas tunnelling across the face of the engine block. If this goes on from any length of time the hot gas will start eroding a nasty little channel for itself which will grow quite deep and ruin the head or block (if the block is aluminium). If the water leak is due to a warped cylinder head then there is a risk of hot gas escaping past the main cylinder seal on one or more cylinders. I think that there's also a note of caution needed if continuing to run the engine when you know there is a head gasket problem.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |